100mm plate obscures power connector on Lenovo LI2323S

Will my display work with that?

100mm plate obscures power connector on Lenovo LI2323S

Postby dougburks » Wed Jul 23, 2014 2:20 pm

Hello all,

I have an Ergotron 45-243-026 LX Wall Mount with LCD Arm and a Lenovo LI2323S monitor. The monitor has 75 x 75 mm VESA mounting holes but the power connector is nearby meaning that the Ergotron 75/100 plate partially obscures the power connector. I can angle the power connector and the bottom screws on the plate to get it to *loosely* fit (see attached picture), but I'd prefer a more robust solution. Any ideas other than cutting the Ergotron plate so it doesn't cover the power connector? What would it take to cut the Ergotron plate?


Posts: 1
Joined: Wed Jul 23, 2014 2:08 pm

Re: 100mm plate obscures power connector on Lenovo LI2323S

Postby ErgoJustin » Mon Aug 04, 2014 10:48 am

Hi Doug,

I'm sorry for the late reply. Unfortunately, there really is no fix. It is uncommon for a monitor to have a rear-exit, power-cable interface so close to the mounting hole pattern. If you had a mount where the plate was limited to a 75x75mm hole pattern, such as our Neo-Flex Arm (Part: 45-306-101), it might work. However, most mounts nowadays combine 100x100mm and 75x75mm hole patterns on a single plate because it is more cost effective and efficient.
Posts: 185
Joined: Thu Jul 24, 2014 10:03 am

Return to Display Compatibility

Who is online

Users browsing this forum: No registered users and 1 guest